September 26, 2020
Unable to read existing hinge brand name. Probably Italian about 15 years old. Grass 170 Degree Hinge for Frameless Overlay Cabinets were already ordered with 4mm Frameless Clip-On Mounting Plates from another vendor.
Diameter of hinge hole is approximately 1 and 1/4 inch.
Edge of door to first part of hole is 1/4 inch
Overlay is 1/2 inch
Screw hole spacing is 1 and 15/16 inch
While holes seemed to align properly, the new mounting plate screws are much smaller than the existing holes in the cabinet. The mounting plate holes are too small to allow the use of the existing larger screws. Do you have any suggestions for how to remedy this issue? Are there any other mounting plates with lager screws? Thank you.