KR-6230 PRODUCTION ENT

Question

Roller assemblies are off an old Pella slider door

1 3/8 inch high

2 inches long hard assembly piece and extender goes out the opposite side of the side the adjustment screw is on approx 3/4 on an inch

3/8 to 1/2 of an inch wide Depending where you measure eg along the interior

Case or slider or the exterior Solid casing

And 11/16 of an inch wide from the edges of the tips that stick out from the side of the exterior casing

Tom · Accepted Answer

We do sell the 81-032B, which is similar in design to your roller, but the dimensions are a little off. I recommend looking over the measurements we show on the 81-032B store page to determine if you could still get this part to work.