My Nu Prime vinyl windows are approximately 30 years old. I am looking to replace the side and bottom weather stripping (seals) on all 10 windows. The photos attached are the best I could get. The channel for the side strip mountings are approximately 1/4" wide. The channel for the bottom strip mountings are approximately 1/8" wide.
Do you have the replacements or anything I can use as a replacement?
Thank You:
John
4 Replies
Tom from SWISCO
Nov 14, 2017 1:45 pm
It's likely that we can supply something, but we need to see a different angle. Can you take a "profile" photo, like the angle in the drawing below?
Example illustration of a cross section.
Quick Learner from Jeannette, PA
Nov 14, 2017 4:48 pm
Photo 3408 shows the side weather stripping. It slides into a "T" channel and has a relatively flat sealing surface extending out of the channel. Photo 3411 is the best shot I can get of the bottom seal without removing the window. It slides into a single slot (not "T")on the bottom of the window and has a round, hollow seal area extending from the single slot about 1/4 to 3/8".
Tom from SWISCO
Nov 22, 2017 8:48 am
It's still incredibly hard to tell. I'm afraid from without seeing a clear shot of the profile, I can't say for sure what you have. I recommend looking through our complete selection of bubble seal here. I think there's a good chance one of these seals can work for you.
Password Reset
Enter your email address and we will send you an email to get you started on reseting your password.
