PGT Window and Door part replacement

Question

Hi,

I need to replace a handle and an opener on a PGT sliding door and window. Photos are loaded above. The sliding door handle just wore out, and the window crank was sheared off during construction.

Thank you.

Tom · Accepted Answer

Thanks for reaching out to us. Starting with your handle, my recommendation would be the 82-030. This should work for your door, but only if the original set has a hole spacing of 3-15/16", same as ours.

As for the operator, would it be possible to see this removed from the window? Your photos here only show the base, which happens to be a design used by dozens of different models. I need to see the whole mechanism in order to narrow it down further.