PGT latch
Thanks for posting! I cannot guarantee that we have a replacement sweep lock that will work as a replacement for your hardware, however, I'd be happy to take a look.
To start, please confirm the distance between the installation holes from center to center.
I would like two of these latches. The distance between the holes is 6 cm.
Thank you,
H. Lipkin
I'm sorry to say that we don't sell a replacement lock that matches that precise hole spacing. 6cm comes out to approximately 2.36 inches, which is just shy of 2-1/4". Therefore our 90-274 is a potential replacement option. Did you make sure to measure from the center of each hole? You never want to measure from the edges of the hole or it will result in an inaccurate distance.
For now, the 90-274 is the only option that may work in this application, but that's far from a guarantee. Your next step should be to triple check your measurements and review those we show for this product. Be especially mindful of the backset, which in the diagram below is shown as 11/16".
