Parts for my Pella sliding patio door screen

Question

I have broken both roller assembly parts for an aluminum Pella sliding patio door as shown in the following pictures. My questions:

1. Is there only one size replacement part, e.g. the one pasted below?

2. Are there instructions available regarding removing remainder of the part still in door frame, installing new assembly, and re-hanging the door in the track without breaking new assembly?

User submitted photos of patio door hardware.

Tom · Accepted Answer

Thanks for posting. I believe this is the 84-105. Check it out and see if you agree.

To install this part, first remove the screen flap from the door frame, if applicable, by pulling the screen toward you. Remove the shipping spacers from the screen track and frame sill. Then, install the screen hangers by sliding each hanger into the top rail holes of the screen door frame.

It's important to note that if the hanger will not go into the top rail hole, you just need to turn it around. It only installs one way.

You then need to secure the screen hangers using the hanger screw pre-installed in the top rail of the screen frame. Tighten the screws until the line on the hanger is lined up with the top of the screen frame. It's then simply a matter of putting your door back in the frame. Let me know if you have any other questions!