Patio Slider Rollers

A quick learner from Longboat Key, Florida says:
I recently purchased 10 of your model # 81-095 and discovered a dimension problem upon install time.

All dimensions appeared right but, looking into the end of the rollers on the door. Your part # has the adjusting screw located on the bottom, nearest the rollers, and the hold in place screw hole located on the top.

My rollers have the hold in place screw head located on the bottom and the adjusting screw located on the top AND it is recessed. Which means my door frame has a hole opening to access the screw. The access hole diameter in the door frames is .325, as shown on my attached drawing.

Can you assist me selecting the correct rollers and allow me to return the model 81-095 I ordered?

User submitted a diagram of a patio door roller.
Profile picture of Paul
Paul from SWISCO responded:
Thanks for posting, Roger. I think you should look at our 81-154. The dimensions are close to your own. Furthermore, the top hole is also used for adjusting while the bottom hole is used for the frame screw. Note the wheels are 1-1/4" in diameter.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)