Patio door roller

Question

It's for an old single pane sliding patio door put in in 1984 in a cheap condo. The roller is taken out by removing the stile and pulling it out. It has some little nibs that are supposed to line up with holes in the bottom fram extrusion but they don't, but I guess it doesn't matter because the door isn't removable and the rubber glass seal and the ruster were holding it in place. The door case has a sticker that has an AAMA sticker with a code of CG, which I've been told refers to coastal glass.

Tom · Accepted Answer

I'm sorry to say that I don't know what you need. This is a photo identification service, so if you want us to make a recommendation for a replacement roller then we need to see it.

Best place to start is to remove the roller and show us a clear photo of the back end, top, and sides. You're also going to want to take detailed, written dimensions for reference later in case there's more than one option to pick from.