Pivot pins with a 1-7/16" hole

Question

Inch-long and hole is approximately at 1 7/16 in was there a number for stamped on it

Tom · Accepted Answer

Hello! I'm afraid we don't have a pivot bar in this style with a hole set 1-7/16" back from the front. Can you double check that measurement? Make sure to measure from the center of the hole, not its edges.

We carry the 26-450, which has a hole set back 1-1/2". That's a close, but not exact. We also have the 26-226 whose hole center is set back 1-3/8". Could either of these work for you? Aside from hole placement they both appear to match quite well.