Rear mount replacement brackets (pair) for sliding rail guides

A home owner from Springfield, PA 19064 says:
measurement from screw in holes to front of bracket: estimated @ 4 2/16"
Thumbnail of the uploaded file named Cabinet drawer rear mount.1.jpg
Thumbnail of the uploaded file named Cabinet drawer rear mount.2.jpg
Profile picture of Bob
Bob from SWISCO responded:

Thanks for posting. See if something like our 32-018 or 32-089 could work as a substitute. You just need to make sure that size of the gap that accepts the track matches your old sockets. You can see the rest of our drawer sockets here

A home owner from Springfield, PA 19064 says:
An additional measurement of the actual track will be forthcoming.
Profile picture of Bob
Bob from SWISCO responded:

Thank you! We'll be here.

A home owner from Springfield, PA 19064 says:
Cabinet drawer rail.1 is 3/4" high
Cabinet drawer rail.2 is 5/8" high

Do you have a recommendation?
Profile picture of Bob
Bob from SWISCO responded:

Ah, I was afraid that was the case. Unfortunately, we don't have any rear socket with an opening that exceeds 1". 

With that in mind, your best bet would be to replace the current track system with one of our side-load drawer track kits, which you can see here, and then replacing the back socket with something more standard, like our 32-018.

I'm sorry that we cannot offer a better solution.

Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)