Reassemble Sliding door handle

Question

The part number I ordered is 82-108 mounting plate. That works well.

But I have two other issues. One is I need one small screw, which I will order. I also need a schematic for reassembly. I must be doing something out of order, because the two smaller screws with white-painted head (the screw I need to order one of) are blocked from threading by the two conical pieces on the mounting plate.

Tom · Accepted Answer

I'm sorry to say that we don't sell the screws that come with the 82-080 kit separately. You may be able to take one of the older ones in to a local hardware store to match up, though.

As for a schematic, we don't have that kind of information. There really isn't much to these, though. The pull just mounts to the 82-108 base plate. There's no trick or anything, so I'm not sure why you're having trouble with it.

It is important to note that the 82-108 is designed to only work on the 82-080 and 82-081 handle sets that we sell. If you have an older version, or something similar made by a different manufacturer, then it's not going to fit no matter what you do. This is a fairly specific part with a very narrow range of compatibility. If your original handle set is even slightly different than the 82-080, then you have to replace the entire thing. The 82-108 alone will not be sufficient.