Looking for a pair of left and right sash cams.
Either need the exact pieces or ones that will work. Please see the enclosed photos and the dimensions below.
Length of the section with the screw hole: 15/16 in.
Width of section with screw hole: 5/16 in.
Thickness of section with screw hole: At the hole is 1/8 in.
At the sloped point is 1/4 in.
The top end that faces upward when mounted in the window sash is not a simple rectangle.
If the top end was a simple rectangle, it would be 5/8 x 1/2 in. But there's a cut-out of 1/8 x 5/16 in.
If you need any further information, please let me know. So far, I don't have the window manufacturer.
I just ordered two of your window balances, series 351 2830 for the same window. I'd like to avoid ordering custom made sash cams in order to save cost.
Again, looking for two sash cams, one left and one right.
Appreciate it.
Tim
Jasmine from SWISCO responded:
April 7, 2023
Thanks for reaching out! Your top sash guide looks a lot like an older version of our 18-066. Look over the dimensions and compare them to your existing hardware to confirm that this will be a fit. Your older version is no longer made but I am confident these guides will work fine as a replacement.
|