Searching for MW Replacement Door Handle

Start a new Discussion

Quick Learner

May 21, 2020 8:42 am

Good Morning, I need to replace the MW sliding door handle and lock. I am hoping you can help me out.
Thank you,
John

4 user uploaded images

7 Replies

Bob from SWISCO

May 25, 2020 9:36 am

Hi John. Check out our 82-086, or if you prefer a handle set in a brass finish, our 82-087. Look over the dimensions to confirm either handle set could work for you.

Quick Learner

May 25, 2020 6:04 pm

The mortise lock looks identical. The door handle is 1 3/8" and the screw set is four inches. Will that model still fit?
Let me know what you think,
Thank you

Tom from SWISCO

May 26, 2020 10:15 am

It is most likely that your screw hole spacing is 3-15/16", which is common on this kind of door. Make sure to measure from the center of each hole.

I'm not sure what you're measuring as 1-3/8". Can you specify what that measurement is?

Quick Learner

May 26, 2020 1:04 pm

In the pictures I sent, the top and bottom of the face plate, it widens out to 1 3/8". I assume your recommendation will fit.

Tom from SWISCO

May 26, 2020 2:07 pm

Oh, I see. Our base plate isn't as wide as that, no. It won't affect the function of the door but there may be a visible outline of the old handle on the door frame itself. You won't know until you remove it.

Quick Learner

May 26, 2020 3:05 pm

Thank you, I tried to order it and it said it was out of stock. Any idea when it will be available?