Shower Door Pivot Hinge Kit Installation

A home owner from USA says:
I am looking for instructions on how to install part 10-081. Do I need to cut the glass in order to install the kit?
Profile picture of Tom
Tom from SWISCO responded:

Thanks for posting. I'm afraid that you can't cut the glass, as it's tempered, but you shouldn't have to anyway. There should be two holes in your glass from where the old 10-081 installed. Refer to the image below. If you did not have the 10-081 installed in your door before, then it will not work for you now. This is meant to be a direct replacement.

top glass clamp assembly
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)