Shower door seal w/drip rail

Quick Learner from Grand Rapids

Aug 17, 2016 2:22 pm

My shower door seal and drip rail is 25 1/4 in length, and does have three screw holes for mounting. The problem is, the side screw holes are three inches from each end and the middle screw hole is 12 1/2 inches from each end. I could cut the 30 inch sweep, but I don't think the screw holes would line up since it shows 4 inches. Any ideas?

3 Replies

Quick Learner from Grand Rapids

Aug 17, 2016 3:05 pm

What I really need is the vinyl sweep on the bottom of the drip rail. Mine finally wore out and I can't find a new one that will fit.

Tom from SWISCO

Aug 18, 2016 10:02 am

If the hole pattern doesn't match, you can simply redrill the holes in the sweep itself. I'm afraid we do not sell the vinyl sweep separately.