I need to replace a sliding door handle as well as the part that the door handle locks to, but I need to match existing drill holes in the door. The drill holes are 5" apart, with a lock hole between the two, 2.5" from each. I will also need the piece that the handle clicks into.
Can somebody contact me to discuss getting the right handle?
Sliding Door Handles
Home Owner from Northbrook, IL
Nov 20, 2020 1:16 pm
2 user uploaded images
4 Replies
Casey from SWISCO
Nov 24, 2020 9:48 am
Hi there, thanks for writing in. Take a look at our 82-081. Review its dimensions to see if this could work for you.
Home Owner from Northbrook, IL
Dec 7, 2020 11:08 am
Julia,
Thanks for this, but it may be more than I need.
The dimensions look right, but I don't need a handle with a lock, because this is for a third-floor balcony.
More important, what do you call the part that fits on the door frame that the handle clicks into? Is it the striker?
Could I set up a time to call you about this?
Rob
1 user uploaded image
Casey from SWISCO
Dec 7, 2020 11:23 am
Hi Rob. The part you are describing is sometimes called the striker, but we refer to it as the keeper. You can see our selection here. Do you have a picture of this part that you could show me? I'm afraid I'm not available by phone, but I'm confident we can figure this out.
