Sliding glass door replacement handle

Quick Learner from Plymouth, MA
Hello,

am trying to identify (in order to replace) a sliding glass door on a patio room. The only identifying marks are in the corner of the glass and they are as follows:
TEMPERED
16CFR1201-CII
ANSI Z97.1-1984
1/8U SGCC-598
AFG
C3721
KM37021
BS6206A

It's 8 inces from one handle to other. Let me know if there's any other information I can provide. Thank you.

Ron
1 user uploaded image
4 Replies
Emily
Emily from SWISCO
SWISCO
Expert

Hi there!

Thanks for reaching out to us. We're happy to help with this. This handle is too damaged to identify though. If this is the exterior handle, can you show us a photo of the interior handle? We'd also like you to confirm the distance between the two installation holes, measured from center to center. Lastly, may we see a photo of the mortise lock? 

Quick Learner from Plymouth, MA
Hi there,

Thank you for the response. So that was the interior handle, but I will upload a picture of the exterior one as well as the lock. Also, the distance between the 2 installation screwes is 6 inches. Let me know if this helps or any other info. I can provide.

Ron
2 user uploaded images
Emily
Emily from SWISCO
SWISCO
Expert

Thank you for the additional photos! We don't sell a handle with 6" hole center spacing. However, the mortise lock shown here resembles our 82-226 which is often used with handles that measure 3-15/16" on the installation hole centers. We recommend you double-check the interior handle's hole center spacing just to be safe.

If it's indeed 3-15/16", we recommend the 82-030 handle set. Take a look at the specifications and see what you think. 

Hole center dimensions for 82-030
Hole center dimensions for 82-030

Dimensions for 82-030
Dimensions for 82-030

Reply to Thread
Current Photos:
Related Products
Related Guides