Sliding glass door replacement parts

Question

I have a 1963 home with old sliding aluminum glass doors. There are two different roller assemblies. The rusty one, with only one screw hole sits at the rear of the door. The rusty one has the pin hole worn, so I cannot just replace the wheel. The one with the two holes sits at the front of the door. I would like to replace both, but I could not find a match on your website. Any ideas would be greatly appreciated.
Thank you for your time and expertise,
Dan

Bob · Accepted Answer

Hey Dan. I'm afraid I don't think this exact roller is available any longer. I don't believe your roller is still available but take a look at the 81-050 and 81-084 to see if these will fit your door. Secondly, take a look at the 81-258 and 81-258S rollers to see if you could use just the inside part of the roller and fit it into your existing housing. Lastly, take a look at the roller and axle kit 81-266 and see if you could get away with just replacing the wheel. Also, look over the related videos that we think you'll find helpful with this repair.