Snapped Pivot Bar, Need Replacement

A quick learner from Ohio says:
The measurement between the screw holes is 1".

Thumbnail of the uploaded file named 77296410_10223143071461970_6054581595778580480_o.j
Thumbnail of the uploaded file named 101633384_10223143071421969_3939870751565283328_o.
Thumbnail of the uploaded file named 77296410_10223143071461970_6054581595778580480_o.j
Profile picture of Tom
Tom from SWISCO responded:

Your pivot bar isn't made anymore, unfortunately. The good news is that the 26-438 can replace it, but you may need to file down the top and bottom sides of the round "collar" that surrounds the tip. Look it over and let me know if you had any questions.

A quick learner from Ohio says:
Thanks, I'll give a try.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)