Traco sliding door handle

Question

Hello,

I looking for a Sliding door handle from Traco.
Have attached picture for reference. I only need to replace the back side.
The length of the handle bar is 10 inch, I open to suggestions too.

Thanks
Jay

Bob · Accepted Answer

Hey Jay. Is the hole spacing, or the distance between the center of each mounting hole, 3-15/16"? If so, our 82-030 could work as a replacement. Our 82-089 and 82-090 also could work, so long as the thumb lever on your old handle set is offset towards the bottom of the pull, rather than perfectly centered.