Window takeout clip part needed
Hello,
We can't be sure with the clip still installed but it resembles a style often replaced by the 16-035A. To confirm that this is the right fit, carefully review the dimensions below compared to your part. Thanks for posting!
i just took out a tape measure and measured what we have now.
Great! Then you should be good to go!
my last message was not quite correct. I have enclosed photos of the windows needing fixed.
Unforutnately, the stamp codes on the balance do not indicate the replacements you need, only the strength of the spring. If you could show us clear photos of both ends of each balance uninstalled, we can go from there. We'll also need to see the spring and pulley connection inside the balance stamped with Caldwell. Thank you!
Thanks for getting back to us. It looks like you are showing the balances stamped with 25 4, which we can supply through a custom order. We'll need to know the number of replacements you need with these fittings and stamp code, with the minimum being two.
We'll still need to see the end fittings of the 25 3 Caldwell balances uninstalled to compare to our inventory.
Below are the additional photos of the 25 3 balance.
Thanks for getting back to us, but we'll still need to see this balance fully removed from the window so that the spring and pulley connection inside the channel is visible. That will tell us if our stock balances will work or if these would need to be custom-ordered as well.
