Wooden Sliding Patio Door Track

The Door slides on a metal track which has a three quarter Diameter x 7 inch long rubber stop on bottom track, However I need a additional x 7 inch so the door stops earlier to avoid its jumping off its track. Also the top of the wooden guide which measures two inches across and has two sides each half inch will need a stopper.

I am attaching two photos One taken shows the bottom track with the three quarter inch diameter x 7 inch long that I need an additional 7 inch to connect to the existing 7 inch.

To avoid the door from sliding and match the stop on the lower portion of track I need a stopper to attach to the 2 inch guide as shown in the attached photo

Please let me know if I can order these parts

Thanks you

Bob

Hello Casey

I am not looking to replace the track it is good The only two items I need are the following

The lower track has a Round hard rubber stop that is 6 inches long I need another rubber stop that would be 6 inches long so that the door will stop sooner when slid open.

I will send you a email with the photo of this stopper that I need to extend so do you have a stopper that measures three quarter inch Diameter with a hole in center measures one quarter inch and id 6 inches long and will fit over the track

Thanks

Bob 

I am attaching the photo of the stopper at the lower track of slider Do you have a part like this I need this as an extension to this stopper

Thanks

Bob