Viewing all customer Discussions for:

Lavatory

Trying to find the correct bottom guide for my shower door.I believe the part I need is the 10- 139 shower door bottom guide but I'm not 100% certain.

We could not find any names on the shower just the parts is all we have and there's no markings on it. Thank you.

Hello, Shower door roller has broken off. Can you identify the part in picture? There is are two rollers per glass for bypass shower door.

I need 4 total, note the small shoulder, almost non-existent...

Don't have any numbers or names on this part. It's for an old shower door.

I need 12 shower door wheels. I done know what size...

I can't find this item anywhere and really would appreciate for your insight The picture is from a shower door bottom area - and shows a deteriorated plastic or nylon guide. There are many similar ones on the market but none fit. The doors are 5/8" thick each and each track (for each door) is 3/4" ... (cont.)

I need replacements for sliding shower door Bottom hooks to keep on track

No identifying info can be found

Please identify the entire knob and bolt assembly. Thank-you.

It is 25" with hole on both sides, approx 1.5" apart on both side. On the back plastic strip which are stick and remain down and stop water when open the gate.

The photo shows the front of the concealed latch and uses a thumb turn knob , I wanted to know if there is a replacement part for the face plate? Or latch faceplate that covers and holds the concealed latch?

Hi, The bottom pivot of my pivot shower door is broken. I could not find the name of the manufacture for this 20 plus year old door. I include a picture of the shower and the broken bottom pivot . Hopefully you can help me to find the right replacement. Judging from the remaining part, I believe it ... (cont.)

I need to replace this same part. One runs vertical along the length of the "hinge" of the shower door and the other is on the adjacent shower wall. The gasket/seal, whatever it's called, is what I need to replace. They're 20+ years old and they are orange and brittle.

This is a pivot hinge for a H bar framed shower door made out of aluminum. Tha bar is 1 1/4" high X 1/2" wide with a flanged top groove of about 5/32" wide and about 5/32" deep in which the hinge is secured with a set screw. Do you have this type of hinge. It is approximately 30 years old. ... (cont.)

I need two of these items. They are show door roller parts and outer cap. They match two others used on the second door and also match two in another bathroom. The only part number I can find is on the inside of the cap. It is 1187908. If necessary, I could replaced all four in this bathroom wi ... (cont.)

This is a bathroom glass sliding door the wheel at the door slide on.

Manhattan shower doors model illusion two doors open in center and slide behind the two side panels. The plastic piece that holds the door to the roller snapped in half. I have photos of the whole door assembly the broken piece as well as the other unbroken pieces still holding the door up. If the ... (cont.)

Parts is on a bathroom door partition.

Looking for some lever handles like the one pictured above. It says hadrian on it