Viewing all customer Discussions for:

Weatherization

Customer says the weatherstripping on the bottom of this sliding door is worn out. Does the information below give you enough to figure what is needed? There is a sticker / engraving on the glass pane, which has the following information: CTG Tempered 16 CFR 1201 11 ANSI Z97.1-2009 SGCC 1804 3mm ... (cont.)

Trying to locate new weatherstripping for two exterior doors. The normal weatherstripping you would find at HD or Lowe's won't work because it's too bulky. My weather stripping has no foam. Thanks for your help! Rick

Oval/Bulb shape with attachment point to one side. No markings.

the weatherstripping we think was destroyed by squirrels. Trying to find a replacement. We cannot find any numbers of model numbers etc. Windows installed along time ago. Can you help us find a replacement? Thank you.

I am having a hard time finding this weather stripping. It is 15/16 of an inch on one side and and inch on the other side. Door is about 24 years old. In fact stopped at Pease and they could not help. It is V shaped as you can see but has a kerf that comes off at a weird location. Thanks for your a ... (cont.)

Trying to find the replacement gasket for my windows and am not certain the correct size. Thanks

The seal is 1/2" wide by 1/4" deep and there is about a 1/4" to seal between the doors. The seal is 7' long. I can't find any name or model on the doors and can't find anyone that remembers who installed them. Let me know if you need more info. Need one strip.

Have a customer who is looking for a replacement for this piece.

Base width and pile height both 9/32". Probably part 58-022 but I don't know meaning of "center-fin seal" in catalog description. Thanks.

I am looking for vertical weatherstripping for three ProVie commercial doors as shown in the attached photo. My problem is that the standard dimension weatherstripping (0.125" base and 0.315" brush) doesn't fill the gap on two of the doors. Do you have a weatherstripping with a 0.125 base width and ... (cont.)

Dear Reader,I'm looking for some weatherstripping to fill a small gap in one of our windows. These are Peachtree (installed in 2009). I couldn't figure out how to pull out the component so I have not provided a "removed" photo.Thank you for your attention.Regards,Ross

The weather striping profile attached has approximately 3/16" wide T that slides into the threshold. The approximate height of profile is 3/8". The length is roughly 52" I would like to find extra material the home has several French doors that use the profile. Thanks for an help in finding. ... (cont.)

Measured old one is 2.9 mmx12.17mmx 37.5 inches

I need approv. 20 ft of this weather-stripping to repair this window. I can also be reached at 732-800-1820.

Hello, I'm trying to get some replacement weather stripping for a whole house of windows. I dug some out of one of them and attached the pictures. The kerf is about 1/4" and the flange coming out is about 1/4" and the return is about 1/8"

Pella outswing door the weather strip is on the perimeter of the operating panel

Stamped ID on window: Caradco. Low E2 IGCE. CBA IGMAC. CIG-3 3-96

Need this type of weather strip for a double hung window.

I'm trying to find the correct window seals for this type of window. It appears to be a welded vinyl. I would like to replace the bottom bulb seal and the surrounding seals. Can you tell me if you have parts that will fit?

There is nothing on the molding we have.