need replacement for Bell-View aluminum windows TILT IN LATCH

Home Owner from Sarasota, FL

Apr 16, 2019 11:06 am

Tilt in Latch that was a 2nd iteration for Bell-View aluminum windows.

I guess Bell-View went out of business. Can't reach them.

1 user uploaded image

4 Replies

Bob from SWISCO

Apr 16, 2019 2:12 pm

Thanks for posting. I think we can help you replace this tilt latch, but we don't have an exact substitute to my knowledge, so I'll need a little information to be able to help. Can you tell us the distance between the center of each mounting hole of the tilt latch, as well as the distance between the mounting holes and the back edge of the tilt latch's body? From there, we'll see what we can identify. Many thanks.

Home Owner from Sarasota, FL

Apr 16, 2019 4:08 pm

Yes thanks for your quick response.
The distance between mounting holes in latch body is 2 inches. The distance from the rear of the latch body to the mounting hole is 13/16 inches.

Bob from SWISCO

Apr 17, 2019 9:31 am

Thanks for getting back to me. To start, take a look at the 26-344. This has a hole spacing of 2". Note the distance between the near hole and the edge of the tilt latch with the tooth is 3/4". See if your current tilt latches has the same offset. If so, I think this might work for you. But compare the shape of the tooth with your old tilt latches as well to confirm. Let us know what you think.