Viewing all customer Discussions for:

23-056 Rear, 3/4" Backset Closet Door Hanger, 1" Dia.

Need input on available replacement parts for 3 sets of closets door thickness: 1 3/8 inch thick front bypass door:1 inch wheel, offset 3/8 inch rear bypass door 1 inch wheel, offset 1 inch

Old (1952?) solid wood closet door rollers needed... I need 12 paired sets! Square flat channel track, Square flat rollers 1 1/4 diameter, 3/4" offset with the wheel coming back 1/2" Any hope of finding? How about just 1 1/4" flat rollers? (I could maybe use existing brackets) Thank you for any ... (cont.)

It says Stanley on it.

Thank you for responding to my request. I am looking to replace all of the hanging roller assemblies for four closets. Each closet has two doors and each door has two assemblies for eight 'front' assemblies needed and eight 'back' assemblies required. I have attached a picture of two assemblies ... (cont.)

Looking for parts or replacement. The roller is 1 inch diameter

This rubber wheel roller is on heavy wood sliding closet doors from the early 1950's. One wheel is broken. Rubber Wheel is half inch wide. Straight bracket is two inches. Replacement plastic wheel seems to be too small for the heavy doors. Thank You.

I need four of these to put closet doors back up

I need these rollers for my sliding doors.

I am trying to identify and obtain proper closet door replacement roller hardware for the system depicted in the attached sketch. The original brackets are missing on the outer door so I am not sure of their exact configuration. The OD of the existing inner door roller is 1 1/16" and it is 1/4" wide ... (cont.)

23-056 roller I need roller track 4' or 6' long , how much with shipping to 48218

I have 2 sliding doors, made in 1955, which have wheels made by "Cox & Sons", Pasadena, CA. The 1" DIA wheels have NO ball-bearings and are badly worn-out, see 2 pix for dimensions. The spades are 1" wide. What are the right replacements WITH ball-bearings you can offer and at what cost, incl shipme ... (cont.)

I have a set of old closet doors. The rollers were kind of worn out. I'd like to seek for replacements. I tried to measure and draw the dimensions. Hopefully those files make sense. Thanks a lot. Amy