Viewing all customer Discussions for:

23-250 75 lb Pocket Door Panel Kit, 36" Opening

This is setup for pocket door at a Health Imaging Center in California.We need new wheel Hardware, as a couple of wheels no longer roll.

Looking for these type of rollers very old. The one wheel one is bent. Heavy duty metal. Door is all wood. Looking to find this exact one that'll work on the track that is existing.I want to avoid demoing wall to get to track. Thank you. MINNY

Wheels are 3/4 wide and approx 1 1/4 apart. Do tou have this part

Looking for these dual hanging door rollers that say GRANT on them. Can't find anything that looks like them so far. Probably 30-40 years old.

Kennatrack mfrd. By jay g McKenna inc elkhart indiana patent pending i need some hardware that would work on this type of track everything I've found is too wide to fit in the existing track

Hi, I need two pocket door rollers.

I'm looking to replace two pocket door roller mounts from a door that looks to have been made in the mid 1960's. I've found lots online, but they seem to be smaller; and not ball bearing. The current nylon / plastic wheel diameter is 15/16." Wheels are about 1 7/8" from each other. Each bracket mo ... (cont.)

Hello,I have a broken roller on an old, heavy closet door. The wheel broke, but I figure I should replace the whole thing. It hangs on the back of the door with a 1/2 inch offset. Attached are photos of the undamaged one.I looked online and came upon your website. I was delighted to see you are ... (cont.)

I am looking to replace 2 of these

I am looking for pockket door hardware. I have looked at your pocket door hardware page bit found no match. Base plate is about 3-and-5/8 by 3/4 The roller wheel is 3/4.

We have 3 pocket doors that were partially installed but are missing the rollers. We don't know what brand of frame or track were installed prior to our contractor disappearing on us and are looking for some guidance on installing the doors. The inside dimension on the track 1 1/4" wide and 3/4" ... (cont.)

Hi. I am trying to locate a replacement pair of rollers for a pocket door I am working on. I see the name ACME on the mounting plate that goes on the top of the door, but other than that, I don't see any markings. I've attached some pictures. Please let me know if I can provide anything else to h ... (cont.)

Pocket door roller

Swisco, Please see attached photo and let me know if you can help us find a replacement roller. There is apparently a capital "H" label or logo of sorts stamped on the roller if that is of any help.

Will this track 23-250 work in my current pocket door opening? I want to make sure the swisco track will work with the door being centered properly in the space that I have.

Hi,I am looking to buy 4 Pocket Door Hangers.Please see attachment pictures.Your thoughts please.Thank you.Best regards,Dominick

1" Wheel O.D 1" x 2.5" plate

It's the top slider but I can't find a replacement since the mounting hole is worn out

Hello, Which track would the Hanger Set Product Code: 23-255 run on.

Hello! Would you have, or can you fabricate, a pocket door roller that matches this item, please? I would need three (3) of them. If you do not have these, can you recommend a place that either carries this type of item or, can fabricate such an item? Thank you very much!!