Viewing all customer Discussions for:

22-201 4-1/2" Pull Handle

I'm trying to find replacement handles for my Hooker Desk drawers. They're 3 1/2" centers. Thank you in advance for your help. Fred

Need to replace 2 drop handles

What is this drawer pull made of? Are the handles and the two end pieces made of the same material? Pictured is my drawer pull. It is 4 1/2" center to center. Is it the same as your 22-201?

Do you have any with 3"center,and 3.5" center?

I need 2 of these handles. I was even able to replace the round part but not the pull. They are 4.5" to the holes even something close will work as they will go on the bed side table that is in the side of the bed that isn't near the others so it won't really be too noticeable. To you have anything ... (cont.)

This bedroom furniture is three years old and the manufacturer does not make it any longer per store where we purchased the furniture. There are no part numbers on the metal.

Huntly Furniture -- 4 1/2" at center.

I have three broken drawer handles on my Thomasville dresser and have not been able to repair them nor find replacements. Mrs Jennie

Antique furniture, some handles breaking

Drexel heritage side 3 drawer furniture. 3 handles broke. 4 1/2 " center to center Not sure if this request went through a few days ago NCO 311 or NC0311 Bail handle is a separate piece

The number listed on our receipt is 50-2305. It looks to be an antique brass finish. Boring is 4 1/4 " . Medallion diameter on each end is 1 1/4 ". Type may be called a swans neck pull???Numbers on flat side appear to be 4344. There is also a number 2 on one side of the swans head and 19 on the ... (cont.)

from a dresser set purchased from Bob's Discount furniture approximately 25 years ago. Marking looks like P-1593. (4 1/2 inch center to center mounting holes) Or do you have something similar?

I'm trying to find a replacement drawer pull that matches this Pennsylvania House pull. it measures 4.25 inches center to center.

The little pin on side of pull snapped off. Looks like River Edge furniture. Thanks!

Then handle is 41/2 inches long with nubs that are approx. 1/2 inch long on each end.

Looking for a replacement pull for my dresser - I believe the full part number is 45175-9167 from Keeler Brass Company

I need 3 drawer pulls with 4 3/4" centers and 1 pull with a 4 1/2 " center. Please let me know if available and about long to receive. Of coarse price for each plus shipping . Thank you Al

My drawer pull just broke. It has the numbers 51998 KBC2003 on the back. Do you carry this? Thank you.

Do you have this handle available?

Need pull size 4"1/2 from hole to hole