Viewing all customer Discussions for:

32-025 Hanging Rail Bracket, 1-7/16" Deep

We are looking for side mount drawer slide socket

I am in need of 2 of these. Only markings are left and right. They are 4 3/4 long and 1 1/2 wide at the top and 3/4 wide at the top. I need the left and the right. Thanks

Came home to find the utility drawer hanging at a 45 degree angle. The culprit is this rear track bracket which had cracked in half. The drawer slide (the part attached to the drawer itself) reads "Unigrass 6600". No markings on the bracket other than "Left" and "Right". Dimensions for the openi ... (cont.)

Hello, I live in a house with cabinets from the 1980s. At some point someone replaced the proper older back wall attached cabinet drawer slide bracket with a cheap, square one that has broken. I am attaching a picture of the one that remains (and that matches most of the other remaining brack ... (cont.)

This is for a drawer that hangs below a board in the back of the cabinet

Need to find replacement or one that would fit that works BETTER then the last two that broke. Poor design but I'm not a carpenter so I must do with what I can. The two I noticed on your site one has the lip on the upper and I need it on the lower and not sure if the other one would work. ... (cont.)

Hi, we are looking for a bracket to hold up the right drawer track in the back of the cabinet. The one we tried (The white one in the photo) offered a very temporary solution. Duck tape was involved! The one on the left is the correct piece. You'll see the measuring tape next to it. I hope that help ... (cont.)

There are no markings on this except right. We appreciate any help

Need this glide hanger. 4 7/8" tall, pocket is 1" and it is 7/8" deep

If I am facing the drawer the right socket broke. H1012 is a number on the socket.

Looking to purchase a dozen of theses parts.

Looking for a slider socket. The pictures I sent are for the right side but need a left side. Any suggestions.

5" long piece that is secured at the back of the cabinet. No names or numbers on it. It is very old. The runner and the connection to this part is 23" long. Can you help us with this?

Photos are attached with some sense of the size. Could not figure out how to find dimensions on the parts in your catalog. Please help. Thanks. Best regards, Chuck

Can you help me find the rear sucker parts please.

The kitchen drawer hanging bracket in my my right hand side has broken, and I have been unable to locate the part needed to fix this, can you confirm if you would have something that would work for this? Many thanks!

Hanging sliding drawer back bracket (left) Approx 4 7/8" height 1 13/16" from top of bracket to screw slot Slide hole is 7/8" x 3/8" Only marking is the word "Left"

Do you have a replacement for this part?

I am looking for the rear drawer socket, but I need ones that have plugs the plug into the rear of the cabinet and the drawer glide sits on this. will your part work for hettich? Thanks for your help. karen

The track fits in this on the back wall.