Viewing all customer Discussions for:

32-025 Hanging Rail Bracket, 1-7/16" Deep

I will need 2 sets of these.

Hello I just purchased a few of your brackets (part number 32-025) and now I'm needing this piece that slides into the bottom of that bracket. Would you happen to have this piece?

Need a few rear drawer brackets.

Track is 23 inches

This is the rail mount on the left side of my cabinet drawer. The one on the right side broke. Can you help me order another one of these?

Looking for the bracket to hang my glider for my drawer back on do you have anything like this

Hello! I have this bracket in the back from our 1980ish kitchen. I tried measuring but it's hard to reach back there. It's roughly 5inches and the rail it needs to hold is 1inch. Thank you!!

I am looking for a rear bracket for a slide manufactured by Grass America and it was put in a Wellborn cabinet.

I need the plastic drawer slider retainer

Xxx

The glide holder is for an American Woodmark Cabinet that was manufactured in or about 1986 or 1987.

Need help finding this part

What's the part that replaces this part?

Yes I have a few questions I am looking for a hanging bracket for my kitchen drawer side panels here is a picture of what I need thanks I was not sure the measurements before purchasing what you guys have thanks

This piece attaches to the cabinet and allows the track for the drawer to slide in and hang.

I would like to get a replacement for the attached picture of my broken bracket

Looking for a replacement holder for the right side of the drawer. One picture is broken one and other is still good.

We had this bracket break off of our cabinet and there is nothing I could find locally here. Does your product number 32-025 fit this? The only difference I see is the width of where the bracket goes mine is 3/8 and yours is 7/16. Everything else I think is close enough especially if I use two new b ... (cont.)

Has a number H-1013 stamped on it 4 1/4 inches tall 3/4 inch wide at bottom Slide is 1 inch tall and 3/8 inch wide

Hello, I have a drawed that is need of repair. I need to replace the left & Right side rails that mount to the bottom of the drawer and I need to replace the left & right side rail that mounts inside the cabinet. I have a unigrass 6600 bottom mount drawer slide that is 21-5/8". The track that th ... (cont.)