slightly different hole spacing

A contractor from athens ga says:
February 11, 2011
trying to replace a window crank that has broken. very similar to the 39-025 BUT the bottom hole spacing that is 1-1/8" on the 39-025 is is 1-3/8" on the broken one. the link also measures 2-3/8 rather than 2-1/4. the 5-1/4 checks. note also that all the mounting holes are just inside the casting lip with the single top hole to the right side of crank centerline and the bottom two just inside the casting also (i.e. the two holes approximately inline with the crank alternate sides.

any help?

thanks
Profile picture of Donna
Donna from SWISCO responded:
February 11, 2011
Hi,
We are bringing in a similar operator with 1-3/8" hole spacing where needed.
I will post again as soon as it is available to view operator with dimensions.
Profile picture of Donna
Donna from SWISCO responded:
March 11, 2011
The operator is now available, take a look at the newly added 39-350, Look-Rusco Awning Window Operator.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)