Looking for surface mount sliding patios door handles

Question

I'm trying to buy replacement patio door handles for my wooden sliding doors. the building was built in 2002, but I don't know where to find these handles.
What I see:

This is a surface-mount pull handle for a wood sliding patio door.
The handle is silver/grey plastic, two-piece, with two through bolts (screws).
Approximate measurements from your tape:

Overall length: About 7 3/4” (almost 8”)
Screw hole center-to-center: About 6 5/8” (between 6 1/2” and 6 3/4”)
Width: Around 2 1/8” at the widest point
The handle is generic with no visible logo (just “Made in China”).

Any help would be greatly appreciated as I would like to buy more

Casey · Accepted Answer

Hello,

Unfortunately, we don't sell a handle set that matches your original. With that being said, you could consider replacing this with a surface-mount set like our 82-005 with 4-15/16" hole spacing. The video below will explain how this can be adapted to use on your door.

Alternate image for 82-005

The only other option we could offer would be to adapt the 82-030 handle set with 3-15/16" hole spacing, which is commonly used with the 82-226 mortise lock. Note that either handle set would require drilling new installation holes in the door. If you decide to go that route, be careful not to hit the glass in the door. Thanks for posting.

Hole center dimensions for 82-030