Looking to change to KeyLock

Question

PGT sliding impact door, looking to convert to Keyed lock exterior handle
- Multilock Mortise with below measurements.
- handle measures 10 inches long with offset thumb lever currently installed, no keyed entry.
- 4 inches between handle screws.
photos attached.

What do i need to get to change to lock with Key and do you have said parts available ?

Casey · Accepted Answer

Hello,

Your mortise lock reminds me of the 82-265, which is commonly used with the 82-030A or 82-030B keyed handle sets depending on if your thumb latch is centered or offset. You would also need to confirm that the 3-15/16" hole center spacing matches up to yours. Thank you!

Alternate image for 82-265

Dimensions for 82-030A