Peachtree Screen Door Roller Assembly

A home owner from Colorado says:
August 8, 2011
Hello,

The Peachtree Screen Door Roller Assembly failed on my screen door. You can see this on the attached picture. I have identified a replacement on your web site as Part No. 84-028.

The only dimensions I need before ordering this part is the distance from the axle of the wheel (near the 2 1/8" mark on the ruler) to the screw at the bottom (near the 5/16" mark on the ruler).

Thank you for sending me this information so that I can confirm that the wheel will fit approximately in the bottom hole of the Peachtree screen door.

Hans
User submitted photo of their Peachtree screen door roller.
Profile picture of Mike
Mike from SWISCO responded:
August 8, 2011
It is tough to measure because the pull from the spring but the dimension you're looking for is roughly about 1-3/4"

I believe the 84-028 is the roller you are looking for. We also have this roller in a metal version, see 84-075.
A home owner from Colorado says:
August 10, 2011
Thank you Mike, for this confirmation.

I would assume that a spring is included with each roller assembly, right?


Thanks,

Hans
Profile picture of Mike
Mike from SWISCO responded:
August 10, 2011
Yes Hans, the spring is included with the roller.
Reply to Thread
Use this form to ask a follow-up question or to share your experience regarding this subject.
(your email address will be kept private and is only used to inform you when a response has been made)