Replacement parts for window
Hello,
We can't be sure with the hardware still installed but your pivot shoe resembles the 15-177 shown below. This shoe is used with the S152 coil springs. You'll need to check both coils for the stamp codes to choose the corresponding strength options. We also offer the 15-143, 15-144, and 15-145 support parts for the coil springs.
Your first photo looks like it could be a type of balance cover. If so, that is not something we can supply but a local hardware store may have them.
As for the tilt latch, the 26-371 would be a good place to start. Review the specifications below compared to your part removed from the window. Thanks for posting!
. I will need edge latches 3 inch long by 5/8 snap on type. I need 12 of those. Inside the window jam, 4 imch by 1 3/8 it has a spring rolled insde , I need 12 of those. Weather stripping on top by the locks 31 inches long. Need 6 of those weather stripping. I'll you another email more pictures
It looks like your tilt latch may be closer to 2-5/8" long. If so, take a look at the 26-243 and 26-244 tilt latches.
As for the balance assembly, the 15-177 and additional balance hardware we recommended would be our closest match but you'll need to remove the pivot shoe from the window to confirm it's a match. It's generally not possible to get precise measurements with the shoe still installed.
For your sash lock, we'd need you to write out the exact distance between the center of the installation holes to compare to our selection.
If you need weatherstripping as well, we'd need to see a clear end profile photo of an undamaged piece uninstalled to narrow down your options.
As we stated in our last response, unfortunately, we are not able to supply replacement balance covers. Your best bet would be to reach out to local hardware stores for that part.