Viewing all customer Discussions for:

Closet

How do I remove the bolt to lift the plastic guide higher so that it stays in the track. I can't see a way to remove it to make the adjustment.

I purchased the bifold track 21-401, I need to know what screws to use, I have to secure into cement, I do not know what size to get.Vickie

I need the replacement part number 3750337 By Acme for a sliding mirrored door. If you don't have that; do you have another alternative?

I'm looking for a bottom track for my Stanley/Monarch closet mirror door 48 inch I believe the model number is 50121991240031 If you could reach out to me and let me know where I can purchase two 48 inch tracks I'd greatly appreciate that. Thank you.

I need replacement parts for old Stanley mirror bi fold doors. Each door and track is 30".

I have a mildor sliding mirror door I need new rollers. DO you have these?

The picture shows only one but there are two detents that ride in a guide rail on top while the bottom has two plastic wheels that roll in the bottom track. This is door off a German made shrunk and am needing two of these spring loaded top pivots. The width is about 1". Which parts should I order ... (cont.)

I need parts for my sliding closet doors. The roller balls are broken and the doors won't slide. I have attached a photo of the part I need. Thank you.

I have a slider with this roller on it. I had to discard the track and need to get another one. I see the track is the 23-240 track and need it in about 60 " long . I dont see that size here? Is there another track that i can get?

I have 3 sets of floor to ceiling metal bi-fold doors and need replacement parts. Please view the images. There are no markings on the doors.

Could you please provide practical instructions and tutorials for replacing my closet's top roller assembly? Thank you.

Marking "R20121"

Need a track for closet door

A very old closet mirror door, would like to replace the roller and track. Can you show me a replacement parts? The length of the track is 96 inches.

I just have the above photos to go from. I think the CoxUSA Double Wheel Top Hanger is the one. What do you think?Thanks!Joshua

Need a part number for the replacement in the picture I am providing. Thank you

Please let me know if you have any thing that would work. I am doing both doors so will be needing full set.

Please advise as to which roller I should purchase for this mirror closet door. Thanks.

how wide is this track?

I have a 50 year old us plywood metal folding door. This rod clamp broke the other day. Will need two. From an old post I see it may be part 21-154. Hope you have them. Thx. David