Viewing all customer Discussions for:

Drawer & Cabinet

looking for Hettich Rear Mounting Sockets for 602 drawer slide -

There's no name but there is a number "3" in a circle near the opening for the mounting screw. These drawers date from the mid 1990's.

I have a part number as 2883164 from Merillat Replacement guide con kit base

I can't find this. It's the rear slide mount. The photo is missing one of the plugs that goes into the back of the drawer slides.

This hinge is from bedroom furniture that is about 25 years old. The markings I can see are an "A" in a circle, then the numbers 7531-2, and then spaced out from that a larger number 1.

Can't fine replacements, weight bearing of 75 pounds for the side mounted drawer rails, rear mounted brackets, pegs fit into holes in the back of cabinet case.

I am looking for a replacement drop pull for a thomasville armoire. It's 6" hole spacing.

Hello - I am looking for a dozen (or more) replacement pistons for soft close drawers. I am told the slide is from Blum, but they do not think that is the case and there is no identification on either the piston or the slide. The piston is 5 and 3/4" when closed and 7" when extended. It's about 3/8" ... (cont.)

Cost?

I am looking for a drawer pull for a Drexel Passage dresser. The part is approximately 3 7/8 inches wide x 2 1/8 inches high. The part number on the part is N-16827 KBC.

Hi - Need to replace a broken Mepla hinge. Part # 664.260 50.00efully extended, the part is 6" in length.

Thomas

Hi, I'm looking for a drawer slide for a 24 inch drawer that goes into a rear drawer socket that is pictured in the upload picture. The back of the drawer slide has a 90 degree bend that slides into the rear drawer socket before mounting the screw in the front of the drawer.

Hello, I need a drawer glide. I can't seem to find the ones I purchased on Ebay a couple years ago.

I need help with this one , I am just missing that part on the video... what can I do?

Looking for these metal rails on the bottom of my drawers. Uses 1 single screw to hold in place at the front of the drawer.If you have longer ones I can cut down to size

rehabbing an antique hutch 2 of the 3 drawers are not working properly

Hello, I have a dresser with Ronthor plastic tracks and wood sliders. Missing a couple plastic tracks. Do you have something that is the equivalent to these? Track is 15" long and the inside of the track is 1 1/8th wide

Hello, I attached a picture of spring that broke on hardware post - this was located on top of assembly - picture attached - this assembly or Lazy Susan is 36 years old

Kitchen cabints / apt building about 15 years old