Viewing all customer Discussions for:

Lavatory

The metal bracket that holds the rollers in my shower door snapped. Is there a replaceable metal bracket. Unfortunately I do not know the name of the door manufacturer. Thank you.

I have a sliding, framed shower doors. The bracket that mounts to the top of the doors which holds the door and has the rollers has broke, I can not find a replacement. The markings on the door are below. The brackets are bronze in color. Would you have a replacement? CARDINAL TEMPERED ANSI Z97 ... (cont.)

Need replacement shower door roller. Looked everywhere and could not find anything.

We have a tempered glass shower. This morning the glider ? That helps the doors open and close broke off. I was wondering if you have this part and close I'm going to send you some pictures .

Door is from showerrite who I guess is no longer in existence. Guide broke. Length is 2.5 in, width is 1 inch and the opening for the guide is about 1/2 cm

I am trying to find a roller for my shower door. Hope you can help.

Corner shower unit curves sliding door, guide roller failure, the support roll looks fine. single pivot mount with with long screw that holds assembly on pivot post. purchased 1999

Hello. My daughter provided me this part and asked if I could help repair it. I am not sure if I need a half round or tee shaped replacement seal? The tee slot is more like 7/32. The Home Depot 5/32 tee is too small. The seal length is 29 inches. The original seal was clear. Thoughts? ... (cont.)

I ordered a 5/32 by 3/4 and it's to large. Do they make one any smaller than 5/32?

Any idea of what part this is? I rent an apartment and their wheels were breaking when I moved it. Now I'm trying to be a good tenant and get replacements but I'm lost! It's a round corner shower door with a metal frame so it can't be drilled through the door. This is the bottoms bracket I believe. ... (cont.)

looking to find a replacement similar to this type of shower tub handle.

Shower door wheel, OD roughly 1". Width roughly 0.250". Precision/quality ball bearing, with installed "nut" on one side (hex size = 0.372") Internal female thread inside nut to accept mounting screw.

Do you carry this piece

Hi, Do you have the vertical accordion plastic piece that goes between both glass doors? As well as new hinges/the rubber pieces that go underneath the hinges? The glass says TEMPERED 16 CFR 1201-II ANSI Z97.1-2004 1/4UA SGCC 3960 Thank you, Lura

I do not know the brand of this pivot shower door i am working with and I apologize for not having pictures installed. I am looking for the shower door sweep and the nylon bushing that fit on the pivots. One bushing is 1/2 inch outside diameter and 5/16 tall (top) and the bottom one is 1/2 outside d ... (cont.)

I have an older glass shower door enclosure. The outer door is falling off the track and not sliding.The model on the door is Allen Stevens Corp A-S 3937. The inner bracket has 4 holes, and the outer one has 5 holes. I need a replacement, and see the ones I have are no longer available. Which model ... (cont.)

Can't seem to find a replacement part. Do you have the part or anything that will work ? Or any suggestions how to get the screw out of the roller. Seems like an easy way to replace my bad rollers but I can't loosen the screw with a screwdriver without stripping the screw head. Any help would be app ... (cont.)

Hi, Do you have replacement parts for the hinges on this older type of shower door? Thank-you Rob

I sent photos of curved shower door and the pulley which i am having difficulty replacing. If you can help me, I would appreciate it very much.

Need 4 of these or similar. Cannot determine manufacturer. These act as guides to hold bottom of door in track. Help. All thoughts appreciated.