Viewing all customer Discussions for:

Lavatory

I am looking for this pivot block that screws on the bottom frame of our shower for the door set into. The female piece broke off. Need replacement if available.

Upper roller retainer and lower guide retainer need replacement parts

My glass, measured by caliper, is 3/8 thick by 33 7/8 wide.. The outside leg is 9/16 and the back drip is 3/4. The 2 sweep fins are 3/8. What part do I use since the model for 3/8 glass has been discontinued. Where were the adults when that decision was made? ?

I am looking to replace the rubber strip on the bottom of my shower door sweep. It is 23" long and 1" wide. It has a ridge on the top like the number 7 that slides into the track on the metal part shown in the photo.

Just what I needed. Installed and works great. Thank yall for such a good product. Clark

Looking for a "T" sweep with about a 1/4 in T. Clear if possible, did find the gray color on the website.

Could you please tell me if 10-127 is the right part for this shower door! Thank you!

Need a bottom guide for shower door that hooks to the track same as product 10-139 except that the holes are 1 inch apart and the guide is 1 inch tall with 1/2 inch channel. Please help!

The slider wheels still work but the retainer slots are worn. What can be done to fix the retainer for this round corner shower door?

a few of them need be replaced

Hello, I am looking for a latch and paddle for a bathroom door. The previous brand model is from Accurate Partitions Corp, with a model number of HACL3A-HACL6N I believe. I have attached some pictures of the parts as well. I was wondering what you had that would be a replacement for this model. ... (cont.)

Hi. Do you have this parts ? I need 2 item with all crews. Best regards

The sweep is too small. The old shower door flap had a sweep measuring approximately an inch long.

I need 2 of these 10-061 - Shower Door Reversible Roller

Need three zinc pivots AXAM part #10002986 Need four(4) adjustable plastic screws AXAM part #10002984 Need two(2) reversible rollers ( no photo) old part # F Need three(3) lower door guides (in photo) old part #O I ho

KOHLER SHOWER DOOE GUIDE FOR: K70318-P3-BH ANMD OR PART #K973501

Hi, I have this Manhattan double doors standing shower which need replacement parts can you please let me know if you have them in stock. Thanks.

it is screwed under bottom door with 3 screws and with seal,seal metal 21,1/2 in.seal

Need to replace shower door wheels and bottom guides for a curved shower door, brand is Maax.

The plastic frame slides into the door bottom and the small sweep slides into the plastic frame. 29 inches long and 1 1/16 inches wide The small vinyl sweep insert is 9/16 inches wide, wouldn't hurt if it was a little wider.