Viewing all customer Discussions for:

Lavatory

I need just the wheel for the top rollers for this shower door. One fell off and disappeared, maybe went down the drain, maybe got thrown out with the cat litter, anyway it's gone. Pictured is the remaining wheel. I have the screw.

Older shower door magnet strip became fragile and snapped once out of its track. Measurements are 70" H for door, 3/4" width, 1/4" thickness

Hello, I purchased the product with code: 10-216 and it worked great for getting my shower doors back "on track", but I noticed one door needs to be raised and have the rollers adjusted so I need to take it out of the shower again. How can I remove the door from the track without damaging the gui ... (cont.)

Please help identify my Corner Shower Door Rollers

I'm looking for the above roller for the bathroom door

Help!! I need 4 of these.

need this parts asap

I am looking for a replacement sweep for my shower door. I need the rubber sweep reaplcement. The drip rail is aluminum.

Can you tell me what part to purchase to replace the under shower bottom door sweep ( metal & rubber) it’s 29” long with 2 screws I would appreciate any help you could provide thank you

I have a curved shower with the plastic grooved type rollers and I need just the grooved roller they have a break in them where you can pop them right on or off and I'd like to buy just that. Is that a possibility?

To whom it may concern: Enclosed are pictures of parts that I need for a shower enclosure. They are Sterling Brand.Can you please review and get back to me? Thank you!

Hello, these guides are on old shower doors from the early 80's. The doors have a flat vertical bottom that would screw into the guides. The guide itself, on one end attached to the flat vertical bottom, and the other side is an oval or oblong and attaches to the tub track by turning the guides flat ... (cont.)

Dear Swisco,See the photo of the door latch mechanism in our toilet stall door at St. Dominic Church, Northfield, MN. Do you have a replacement knob assembly that will work on this latch?Richard

I need to replace the old seal

I can't find the brand or model

Hello, I’m looking for a replacement set of hinges along with the threshold that attaches to the shower curb and holds the bottom hinge in place. The upper hinge attaches to the wall. I am including g pics. Please let me know if you can get this type and or any information you might have. Than ... (cont.)

Missing inside plastic block that goes against glass

seal for the side of a glass shower door

I am loooking for this particualar shower door guide. There are two on the bottom of the door ad two on the top of each door. It lood like the screw hole is stripped and Ill need to drill a new hole. The problem is I cannot find the shower door guide shown below. Can you help? AJ ... (cont.)

Im looking for replacement top hinge but my door is 1 1/2 in wide