Viewing all customer Discussions for:

Lavatory

Hello, I've removed the screws here but that sweep part is stuck on. Should I remove that in order to replace the plastic that keeps the water from leaking out of the shower?

Does Swico have sliding shower door parts shown in the attached photos? I have a need for 2 units.

One photo is of my 20 year old, 24" wide shower door. What is showing is a temporary rig that does not work. Another photo is of the drip tray that does not hold the seal. The third photo is an edge view of what's left of the seal that slides into the bottom section of the door. I have been unable t ... (cont.)

Having a hard time finding this replacement shower door frame bracket. It holds the frame together and tightens it in position around the glass.This is a shower door bracket for a hinged shower door. It holds the glass inside an aluminum frame.

This Holcam shower door was purchased in November 2016. The photos show a broken support at the bottom which the hinge goes through measuring about 3/4"x3/4"x1/2" in size. One photo shows the intact support at the hinge top. Holcam has been no help, nor local suppliers. Everyone just wants me to pur ... (cont.)

Having difficulty finding. 21" wide 2 peaces in Crome with plastic sturdy sweep. It is attached with screws to inside of pivitol door and second piece has sweep that slides in and screwed on. Do you have anything like that. We removed original cleaned it up but sweep will not slide in bc the metal ... (cont.)

Aluminum Shower door part needed. Shower door shows it is manufactured by American Shower Door Co. Inc Santa Monica, CA 90404. I am hoping yo replace this part as the shower door is still ok. So far have not been able to find this part. Amazon has parts similar but they are much shorter. ... (cont.)

The shower door is about 24" wide. The gasket tube runs along just the bottom. Pictures include the bottom of the door that fits over the tubing gasket. Thank you.

I need to replace a shower roller for a glass circular shower door. I attached photos and wondering if 10-058 would work? Or do you have any other suggestions

Lock had a peg that was coming out from the back side... but it broke off. That Pig went into the little hole when the mechanism was assembled back together

Locks and brackets neededWe are looking forward the knob brackets and need a price please

This had a clear vinyl bottom seal and unfortunately I did not keep it. The receiving channel appears to be 4-5/32" round. Do you have a part for this?

Hello, hoping you could help identify the correct shower door roller based upon the pictures I provided.

do you have the lower slowed guide with deeper groove.When the door is closed the bottom comes out of the track.I have pufchase from you before and was very pleased.

Greetings, I have identified the latch as a Swisco 10-516. It has the 1 7/8 center to center holes. All the other parts is what I need help with. They also have 1 7/8 holes center. Thank you!

bought shower door kit back in 1995 anyway - I kinda broke 2 plastic tube nutstaking it apart to clean moldI am in need of helpif you have 2 nuts the plastic tube nuts are 1 1/4" longapprox 5/8" diameterthreaded insideThank YouPauk

This is the hanger on top of a sliding glass shower door. I would need 2 of these parts. Thank you.

Looking to replace old Maax Shower Rollers and accessories.

I am looking for these lower door sliders. They lock into the lower door frame sill and into the bottom of the door. They slide in the sill track and stay stationary on the bottom of the doors.