Viewing all customer Discussions for:

Lavatory

Trying to replace my sweep (rubber piece) in the drip rail. Having the hardest time and it's an old shower around 15 years old I believe. The rail is 20 1/4 inches long and the screw holes to go into the shower door are about 3/4 inch from the edge. Lowes only had ONE kind of clear sweep....like ... (cont.)

I need to locate the appropriate door hardware rollers. The corner shower was purchased in 1999. Do you have a universal type door roller?

No markings, screws go into a vertical opening in the plastic guide

Swisco's 10-324 (with #6 33-071 fasteners)did the trick for replacement of Shower Sweep and Drip Rail dilemma! Two additional points: 1) Recommend anyone buying the 24"er be prepared to snip off 1/2 inch in order to fully close the shower door. I did not own an aluminum metal shear, ended up ... (cont.)

How long is the screw that comes with this? Thanks, Michael

I need this seal for both doors, I believe.

Im looking for this particular part on your website to order for out shower unit. Thank you in advance.

I have a fiberglass one piece corner shower stall unit,the current shower door drip rail does not extend back into the shower stall,because the hinged shower glass wall is not straight to the door it was designed taking a 45 deg. turn,so when the door is opened at 90 deg. the water drips on to the ... (cont.)

I have a semi-frameless shower door and need to replace the shower sweep. The size is 1/4" thickness and @20" in length. Would your item # 10.328 fit this door? Thank you. Raymond

I have a 24" framed shower door that needs the drip deflector replaced. No fasteners, old one adhesive attached. Please advise.

Hi- I want to know if a door sweep you have would be available. I would like to replace the sweep and not the whole drip and sweep. Also, do you have double tape or do I need to purchase it at a hardware store. This drip was installed that way and there are no screws.

I'm looking for the appropriate piece for the bottom guide of a sliding shower doors. The thickness of each of the 2 doors are 5/8th inches. The width of the base of the shower door assembly is 1 5/8th inches. There are no holes on the side of the doors on the bottom and there are no holes on the ba ... (cont.)

I purchased two (2) item # 10-152 Shower door roller assembly. The original is similar only the roller is off-set. I installed the replacement roller assembly. Seems ok but I may need to replace the other off set assembly to be the same as the new straight assembly.

need a wider bottom door seal for my glass hinged shower door.

Hello, I'm searching for a round replacement wheel. This wheel is part of a round door corner shower. The wheel is about 7 millimeters thick, and about 26 or 27 millimeters in diameter. The metal middle has a threaded hole to allow a screw to attach and the bearings allow the wheel to spin with ... (cont.)

Having trouble finding this anywhere.

looking for parts

I have the 10-325 shower drip rail, with the black rubber seal. However, I'd like a more pliable contact strip. Can the clear vinyl 10-321 fit into the mounting channel on the 10-325?

This shower sweep is for a home shower constructed in 2006. Shower sweep looks like product 10-325 but it has no screws. It is a peel and stick type. Do you have a replacement for it?

Hi guys, my shower door is a 1/4 tick. I only see a 3/8 drip rail do you think it will fit on my glass it is only 1/8 difference.