Viewing all customer Discussions for:

Other

Trying to replace this stripping.

Hi, I'm looking for replacement clips that hold the glass panes in an old aluminum (maybe steel) storm door. One is missing, and I fear that the window will pop out every time it closes. I don't know the manufacturer or vintage of the door, but I believe it's 50-70 years old. Any suggestions you can ... (cont.)

Need some help identifying the correct pest to order. The metal section of these measures 27". Please see attached photos with the code stamp. I need 4 of these to repair a clients Millgard windows.Todd

Cabinet pullout replacement.? This part was attached to the back of our base cabinet, which the drawer slide bracket sat into. Thank you for your help!

The windows were purchased from a vendor known as Fleetwood in 2017. If you can help me identify the parts, I can replace them. Thank you. Jolene

After replacing the Nylon bushings, pivot pins, and springs on all four doors, one pair won't stay shut and pops open. The doors close without interference. What do I need to adjust? Thank you, Juan

I need right and left. The length is 2 3/8 and width 1/2

The swinging lounge broke on my patio door, and I cannot find a replacement to save my life. Any help would be much appreciated.

Hi gentlemen, I have been trying to identify window sweep latches so I can replace those that have broken. I have been unable to identify the manufacturer of the windows. Below I have the measurements of the sweep latches. Attached I have photos of one of the broken sweep latches. I hope you guys ... (cont.)

I need 4 channel balance units for 2 windows. The tracks are about 1/2" wide and the metal part of the track is 19 3/4 " not including the end clips.The total length including the plastic end clips is 21" The only marking on the channel is 19 5 B.S.I. pa.

I need a replacement for these window lock pieces.

Pella double hung windows from Lowe's in 2006. Metal is 22 inches long, labeled 22C BSI. Rivet for bottom of spring broke off, black plastic sash guard at top broken. Pivot lock shoe is 1 inch. House guest thought windows opened by sliding and tilting?! Managed to get the other 3 balances back toget ... (cont.)

This is a single sliding door on round bar with rollers on one glass, other glass is fixed position. 3" wide Also need stainless steel C channel 78 3/4 × 3/4 x 1 3/8

Lock mechanish not working properly Once lock position then it can not unlock It's GU model

I'm looking for pella balance 26c ib8 rm

As shown. The top latch on French doors is broken I am not sure if I can push the lock down from the top to open it. The door is metal Any ideas. Thanks. Bruce

Need to replace both sash balances left & right. Rail is 22", overall length 23", width is 9/16. Stamped on metal 21 3 AL Caldwell

Milgard C650 Ultra in Black Bean windows. I need eight handles. 6 for awning windows and 2 for regular windows if that matters.

Do I just pry this out? I have no info on the windows. They are 12 yeArs old They are double pain windows in aluminum frames painted white. What more info can I send to help. It they pry out, I can take measurements Thank you Bruce

Hi, I attached picture to the Sliding Glass Door lock i need to replace. can you please let me know the product i need, the lock trim + Box.