Viewing all customer Discussions for:

Other

Can you help identify the part I need to replace the door handle mount?

The rollers themselves are about half inch in diameter on the outside and 3/16 wide, and have a metal outer ring and a brass inner axel. The rollers rests in a u-shaped metal saddle which rests inside the plastic casing. Looking at it from the bottom, the plastic holder is about 9/16 long and about ... (cont.)

I'm looking to replace my window balance assembly for my Simonton windows.

The thumb-lock mechanism has broken and we need to replace either that assembly or the whole lock system.

I'm looking for a channel/sash guide top piece for my windows. I've attached photos of it. I can't seem to figure out which one it is on your website.

This part came from my window

I need the locking mech for this Pella door. It is currently upside down and it will not stay latched. It is also a keyed exterior. Lock keeps springing to center and not latching, whether closed or open.

Don't know what it means

The little white guide with the two screws has snapped off. That's really the part that I need. But if I need to purchase the entire mechanism then I can do that as well. I did find the name Truth 31401 stamped into the metal arm. That's part of the mechanism

do you sell any of these pulls. the finish is antique brass with red oak insert. 4 1/2" center to center. it is for a furniture traditions dresser.

Need cams that are 12.5 wide at the top

All my sash windows have identical tilt latches, but several are broken. I would like to purchase 5 LH and 5 RH

need vinyl window sash vent stop- size: 2.5" x 3/8"

The house was built 1989 i could not identify the balance in the Anderson window part number

Looking for replacement polybau window vent covers and window flip latch accessories to replace my missing and broken parts. See photos attached.

I'm a contractor and a past purchaser Raymond White RW Construction 732 513 1366

The markings on it are: 26 3 AX CMC 11. The metal piece is 27 inches.

Larson storm door

We need to replace our current handle with one that will lock on the outside with a key. I think the door is a ply gem from Home Depot. It is our primary back door. I can take more pictures.

I am looking for an Alside Excalibur Casement Window crank and insert locking key. Please reference the picture I have provided. Thanks.