Viewing all customer Discussions for:

Weatherization

Hello I'm looking for the right weather stripping for an older millguard patio sliding glass door. It's the type of weather stripping that has brush and a piece of rubber for seal. It goes in the tracks. Thank you very much

I have a couple of sliding patio doors that were installed late 80s early 90s. I am looking for this square, weatherstripping that slides into a groove on the jam and on the stationary door. This looks to have a wall inner seal with a vinyl or exterior seal. I am assuming it was screwed on after it ... (cont.)

Hello there, I'm trying to identify which Pile Weatherstripping I need for my sliding door, I attached a picture with the numbers the door has in the glass also the Pile Weatherstripping measurements. I'll be more the happy if you can help me with this issue. Antonio

I'm looking for weather-striping for my windows. The attached pictures shows what it looks like. These are double hung windows with a piece of this weather-strip on the bottom jamb, top jamb and middle between the upper and lower window. The weather strip is 34 1/2 " long. It measures 5/8" wide and ... (cont.)

I'm looking for replacement seal/gasket to replace these on the bottom of my lower sash units. There is no foam in them by the way. Do you have anything like this?

We are trying to locate some white glazing spline for an arched window that we cannot locate a brand name from. It is a stationary window and this glazing spline is on the exterior side of the house. Any help would be appreciated.

Need weatherstrip for 2 windows. Vertical pieces 70", Horizontal pieces 28". Total 392" plus scrap.

Need to replace gasket material

These are the window seals on JELD WEN casement windows on a house constructed in the early 80's. There are 2 seals on each window, one on the sash and one on the frame. I need seals for 3 windows, each measuring approximately 64 1/4" high and 23" wide. I also need the window operators for 2 wind ... (cont.)

Help identify weather stripping.Base 3/16" Pile 1/8" There is a thin rubber strip as well.

Approx 3/8 base with 3/8 inch high

I need help identifying the correct replacement for the degraded weatherstripping on balcony doors. I attach photos that I hope will help.

My contractor is trying to replace the weatherstripping on Andersen Millenium series 400 window installed in 2003.

Looking for this snap-in window glazing... any suggestions on the actual model number? The glazing is extremely brittle (picture shows glazing wrapped in tape to hold shape. Constructed a SketchUp model with dimensions to assist (attached). Thank you

the measurements of this is 3/8 by 3/8. Which should I buy?

Weather stripping needed.

Please see beige Q-Lon weather seal pictures attached, would you be able to find me a match? Thank you!

I am trying to identify this seal.

Looking for White pile weatherstripping for a vinyl door frame dimentions are as follows width of base- 3/16" Height of pile- 1/4" pictures attached

weatherstripping has a 1/4" wide flat base, a 1/8" high flat stalk, and a 1/8" diameter round sealing top. 2 photos enclosed