Viewing all customer Discussions for:

40-077 Standard Door Closer, Drop-pin Attachment

Looking for the plastic jamb connector parts for storm door closer. The part slides over the bracket that attaches to the door jamb

I am looking for this larson pneumatic door closer attachment bracket

I need this fof my outter swinging door on my screen egg nened in patio. I slso need one for my inner swinging door. The bracket is broken that attaches to the door hinge support frame.

The spring door was flung out by the wind causing damage to the spring.

Wind bent bar when very gusty. The total length from pun to pun us 12 inches. The bar is 9 inches. Cannot find them that short. No numbers shown in part!

Hello, There is a door, lower level side entrance. The home is 20 years old. As you can see from the pics, water is getting in between the storm door and the wood door due to the gap from the sweep and the 1/2" variance drop from one side to the other. It's a typical 36" door. What do you recommend ... (cont.)

Do you sell a bracket like this? It is similar to your in swing door bracket, item 40-006, only upside down. It would need to have a pin and a c-clip to hold the plunger on it.

Need replacement

I recently purchased a Larson Pembrook aluminum screen door from Lowe's. I want it to be an inswing door that will be mounted to the existing 4x6 treated post of the screen porch. Do you carry the mounting hardware and handle set to accommodate such?

upper and lower hinges and closer. screen door is 27 3/4"W x 77 5/8" H

I wanted to install an in-swing storm door on my screened-in porch so that I wouldn't push guests off the landing when I opened the door. The Home Depot employee who came to measure the door frame said that it could be done with a pre-hung door but not a storm door. I conducted an internet search b ... (cont.)

the pump that closes the door

Pella storm doorI want to purchase part 31320-77-312614

Hi Swisco! Here are my front and rear screendoor sets. The front now has a broken spring, and I've replaced the back door's spring several times. Think its time for some new hardware. Could you guide me to the correct sets? Both have keyed locks but I only use the interior locking mechanism. Tha ... (cont.)

I am installing a Larson (Savannah) screen/storm door and want it to swing inward. I noticed that I needed product #40-006 (bracket), which I ordered already. QUESTION: I noticed several other posts that you recommend product #40-077 (Standard door closer pin attachment). CAN I USE THE CLOSER ... (cont.)

Looking for these parts. Latch broke off a while back.color is bronze

Hello,I have a screen door that currently opens out. I need it to open inward. I need the parts to make the switch.Thank you,Bill

I need to replace the upper and lower door closers on my cole sewell estate series storm door.

How do you install the close cylinder for an inside swing door. I did purchase your inside swing close bracket and the close cylinder. I would like a sketch if possible. Thanks! Sam.

Today I received a 40-015 Heavy Duty Door Closer and a 40-006 Inswing Bracket to use on an inswing storm door. Just placing the parts against the jamb and the door frame I don't see how the torsion bar mount of the closer is going to work in this application. Your other closers have a pin mount on t ... (cont.)