Viewing all customer Discussions for:

55-029 3' Snap-in Glazing

Hi I am looking to purchase 1/2 x 1/2 90 degrees glazing beads can you please help me out i need in bulk for big projects. Thanks Harry

Have an old (aluminum) Garden Window ? House built in 1991. The window itself is holding up fine and it is in good shape but the plastic molding around the individual windows is deteriorating from age and weather.Appears to be a ½? plastic molding that encompasses each window in the unit. The origi ... (cont.)

please help with identification, you have one similar but dimensions are a little off. This measures 11/16 x 11/16Thank you,Richard B.

Hello, We have a few Viking windows that need new glazing. What glazing is the image provided? If this is not available any longer, is there a comparable glaze type. Best regards, Maurice

The seal is tan and is 5/8" x 5/8" with a groove in the outer corner. The seal was installed about 22 years ago during construction.

My part is very similar to 55-080 except for the dimensions are slightly different. Overall height is 7/16", glass seal edge is 1/2", and offset hook is 1/16" from top edge.

Hi, can you please tell which what kind of glazing I need to replace this?

do you have a replacement for this beading? It measures 9/16 x 9/16 inches. Thank you very much.

I have old 1998 Champion windows and the exist glazing bead is brittle and cracking. I am looking for a the replacement bead that matches the photo submitted. Both sides are approx. 1/2 inch in length with the glass slide being slightly curved. Can you recommend a replace bread for these windows? ... (cont.)

Hello, Please help with finding replacement for snap-in window glazing beads we have pulled from a dual pane aluminum window installed in 1999 (the year my house was built). When it was pulled from the window it's came out almost flat (Please see image IMG_2172.jpg). Thanks for your help, ... (cont.)

Insert side is 7/16 to the notch lock. Window side is 5/8. Windows are 26 years old and I can't find any branding.

We cannot clean the molding from the existing pieces and would like four new ones.

This is for a basement window. 3/8 U and 1/2 wide. It is similar to one of your products I order but mine has a ridge on the curved end which snaps into the window frame which is aluminum.

I need at least one 34' section of snap in glazing that matches the profile in the attached photo. It is for a BetterBilt single-hung spiral-balance non-tilt insulating-glass window.

1/2, 5/16, 5/16"

Looking for this glazing bead, or a sutable substitute for a MASTERViEW exterior window. The windows were installed in the mid 1990's. The exposed width of the bead on the glass is "15mm or approximately 5/8"

Is 55-029 the correct window glazing I need to replace this ?

Hi, I am looking to replace the glaze beading around one of my windows. Trying to figure out where I can get a replacement. I have attached photos of it, I didn't see any sticker on the window slat, but inside the frame I saw that it was Kresmark. Looking at it, it is just a 'V' shape with a small i ... (cont.)

Doug & Kay

Hello, Trying to find a snap in exterior glazing for some windows. I do not know manufacturer. Thickness is .02, but I presume thicker would work. -- Thanks Ken