Viewing all customer Discussions for:

58-008 Prime Door Seal Set

Just need the door strike side for in swing atrium door

I have attached photos of weather strippping for my door. It's magnetic. If you need more measurements or a piece, let me know. Thanks

Hi, the attached is a weatherstrip I pulled from the front door of a single family residential property, Chicago suburbs. Slot mounted but the slot is perpendicular to the jamb (same plane as the wall), as opposed to parallel to the jamb. Cannot for the life of me find this profile anywhere. If I di ... (cont.)

Good morning,. I am in hopes that you have what I need to make replacements.The door sweep is 32 inches by 1 3/4 width ( outside measurements). The sweep has a thin lip on one side that slides in to a groove on the door , while the triangular piece is pressed in on the other side.The door gaskets ar ... (cont.)

Need this weather stripping

Hi - I am trying to track down weather stripping for a 50 year old steel exterior door.4 Photos attached. I dont think what you sent below matches?.. your option 58-008 is missing the internal magnet. (Black)Thanks!

Dear Swisco experts, I am trying to find an old fashion weather stripping for doors (used in 2003). Please take a look at the attached photos. Do you have this type? Thank you! YUE LI

need to replace magnetic weather stripping in the door frame...ordered frost king from home depot, does not allow proper door closure. is your product made for thermwell products co.?manwah,nj?

Hello, I am seeking magnetic weather strip for Sears storm door to fit in channel as shown. The seal is 1/2" wide and the T channel is approximately 3/16+/- Thank you

I'm not sure what type of seals this is It is magnetic. Not sure who they are made by. Would very much appreciate any help you could offer. Thank you. Jimmy

top seal of the eagle door

341 and 343 are photos of the left side of the eagle (350) door seal 345 and 346 are photos of the right side seal 350 is a photo of the door

Hello SWISCO Support, Good Afternoon, I have a 1996 36" Stanley steel entry door with magnetic weather stripping that is worn and needs replacing (see attached photo #1). Also one of the retainers on the adjustable threshold is no longer holding the wooden part of the threshold in place any any ... (cont.)

The weather stripping has rotted. Out at the bottoms of 4 windows. I'd like to replace. Each button is approximately 27 inches long. In total I need about 12 feet that I can cut to the needed lengths. Can you help me?

I have a circa 1990's Sears Best storm door. I'm looking to replace all of its original gaskets. One of them is magnetic. Please refer to attached photo. Thank you, in advance, Terry E.

Is this a Stanley? Spline is 5/16". Width and height are both 1/2". thanks

Not even close. (Suggested part 58-181) The kerf comes off at a 45 from the square channel which measures approx 5/16" od. The bulb is opposite corner from the kerf and measure approx 1/4" od. Please help

I have 2 Stanley doors that are about 25 years old. I ordered (2) 58-008 seal kits. Our doors have a compression seal on all 3 sides, right left and top. The kit has 1 long compression seal and 1 long magnetic seal and 1 magnetic seal for the top. Do I have the correct kits for my doors? I also ... (cont.)

Trying to locate this magnetic weatherstripping for a Mastercraft door.

Hi, Do you have this by chance available for purchase?