Viewing all customer Discussions for:

58-055 9/32" Bubble Seal With Angled Base, 25ft

I do not know the window brand. Can you help identify this window stripping please. Thanks, Curtis

Hi, I'm looking to replace old weatherstripping on my windows. I measure the bulb size approx 1/4". Bulb is foam-filled. Kerf is 1/16". Other dimensions in photos. I can't identify my window type, they are circa 1996 wooden windows. Thanks! JT

Can you advise me on what gasket to order, these windows are leaking from the top seal, it appears to not have the ability to fill the gap to prevent water from intruding. These were installed in 2014 and I believe are Jeldwen W5500 Series, they are wood interrior and metal exterior. Thanks in adv ... (cont.)

I an trying to replace the weatherstripping located at the inside lower part of the upper window where it seats against the "outside" face located at the top of the lower window. The window latch pulls these two faces together. It is an inverted "V" with a piece that slides into a grove on the upper ... (cont.)

Where can I source some of these? Thanks, Andrew

Can't find any markings on this casement window. Just bought the home and don't know the age of the window.

Hi there, I am trying to find replacement seal for our windows. Attached are the dimensions of the existing foam seal along with the window and sill. Color is beige/pebblestone. Thanks! -Ian

I've looked at the selection you have and the dimensions dont quite match - is there a close approximation you supply to that in the photos - its very persished.

Moulding has no marking. Corp is looking at replacing all moulding. 36 inch front doors and 32 inch swing doors.

I have more than a dozen Kolbe & Kolbe wood casement windows which were installed in 1994. I have attached a photo which shows the window. The weatherstripping needs to be replaced. I have attached a photo which shows the weatherstripping. I measured the bulb portion of the weatherstripping with a ... (cont.)

i am looking for the pella lock stile weatherstrip for the designer series sliding glass door. this seems like it would be a common replacement as it is on the edge of the moving door but i have not been able to find a replacement. the photo below shows the bulb is 5mm x 5mm and the u shaped width ... (cont.)

I'm looking for Bubble Seals for my Vinyl Windows. Windows are Diamond Line 2000 from the Lumber Yard installed in 1999. Seals are dry rotted and I am looking to replace them.

Need to replace the weatherstrippin on the patio door. Dont need a large piece but hope you have it in stock. I believe the bulb diameter is 5/16" The Kerf barb is 1/4" TheFlat fin is 1/2" Please help. thank you so much.

For replacement purposes I am looking to ID this window weatherstripping.

I am looking for weather stripping. Used in Quaker casement windows in 2009. My windows are 28×58 in. I need enough for four windows.Thanks for the help

Hello, I am trying to find Jeld Wen or similar Replacement vinyl windows seals for our old Jeld Wen windows. Most are hand crank. Photos have the number from the windows.Thank you! Kevin

I'm struggling to find the correct weatherstripping to replace on my windows.

I need weather stripping for several windows.

Q-Lon style Kerf-in type 1/16" kerf spine 5/8" overall width 3/16" projection/bulb Foam core with vinyl cover

I am looking to replace weatherstripping on a couple dozen Norco windows from the late 80s. Width is 5/8" and kerf is 3/8".