Viewing all customer Discussions for:

23-015 Top Roller Guide

Do you have this roller ?

One inch wheel. No offset

There are no markings on this part

Looking for these to replace old ones

I HAVE A NEED FOR A FLUSH (NO OFFSET) ROLLER BRACKET (?) WITH CUTOUTS FOR FLATHEAD SCREWS. I HAVE A KENNATRACK SET ON ANOTHER DOOR SET THAT HAS THE FLUSH ROLLER. THE REAR DOOR ROLLER SET SHOULD PUT THE INSIDE DOOR AS FAR AWAY FROM THE FRONT DOOR AS FEASIBLE. THANKS

Seeking the following Top Roller Guide Part - Qty - Unknown Bearing is riveted to the bracket at one end. Kilian Bearing with 1" OD and a .210" Width. ID is unavailable due to the rivet. Bracket measures 3.103" long,.994 Wide and .55 Thick. Has an oblong Hole thatmeasures1" long and .250 wide ... (cont.)

Can you tell me if any of your Hardware will replace the pictures I'm attaching? The wheel appears to be one inch in diameter. Do you think a 23-0 1 5 will work well? It is from a sliding door, probably built in the fifties , that had a piece of plywood that was sliding as the door Thank you ... (cont.)

I need some nylon replacement rollers for sliding panels on my bedroom furniture bought 45 years ago from Carlton House. The broken rollers are riveted onto a metal mounting bracket, but I can use replacement rollers with a nut/bolt that would fit the quarter inch hole the rivet is in. The rolle ... (cont.)

wood closet sliding door. Kennatrack is stamped on part also a letter "c" wheel is 15/16 bracket has no off set and is 2 and 7/8 long